It takes some time and practice to get the origami of a flower… but once you learn it, you can show all your friends your new specialty! This article shows you how to fold origami paper to make a tulip.
Steps
Step 1. Make sure you start with a perfectly square piece of paper
Step 2. Start by arranging the card so that it looks like a diamond
Step 3. Fold the bottom tip up to the top
You should now have a triangle.
Step 4. Fold the triangle in half by folding the left tip over the right tip
Step 5. Unfold and repeat the fold, but in reverse
You open. You should have a triangle with a mark along the center.
Step 6. Fold the tip of the bottom left triangle over the top and center so that it meets the top tip
Mark the fold. Do the same with the bottom right tip. Mark the fold. Open both ends.
Step 7. Turn the model upside down
Fold the left and right tips down to the bottom. You open. You should now end up with an upside down triangle and three different fold lines.
Step 8. Place your fingers between the two flaps at the bottom tip of the triangle (one flap on the front, one on the back) and separate them, while using your other hand to hold the top in place
Step 9. Using both hands, push both ends in and down, so that the two outer fold lines meet in the center
As if you were "crushing" the triangle.
Step 10. The centerline of the crease should "pop out"
Fold this protruding flap to the left. Flip the model over and fold the other protruding flap to the left.
Step 11. You should now end up with another, smaller triangle
Step 12. On the lower left tip, you should have two layers
Lift the top one up and fold it to the top of the triangle.
Step 13. Repeat with the lower right tip
Step 14. You should now have a smaller diamond in the center of the triangle
Fold the left tip of this diamond to the right until it meets the right tip of the diamond.
Step 15. Flip the model over
Again, fold the bottom left and bottom right tips up until you meet the tip of the triangle.
Step 16. You should now have a diamond
Lift the top layer on the left side of the diamond and fold it to the right until it meets the right tip of the diamond.
Step 17. You should now have a diamond that has no seam on either side, only crease lines running through the center
Step 18. Fold the top layers on the right and left side of the diamond towards the center, and insert one layer inside the other
(Look carefully at the edge of each layer, there should be two layers inside one, forming an opening. Insert the tip of one side into the opening of the other.) Squeeze and flatten the model.
Step 19. Turn it over, and repeat the previous step on the other side
Step 20. Lift the model, and turn it so that the swollen end is facing you
Pull the tip away from the bottom, and you will see a small hole in the base of the model. To facilitate the next step, you may want to use a pencil or pen. Push it into the hole to widen it a bit and then take it out.
Step 21. Place your mouth against the hole and gently blow into it
The model will swell.
Step 22. Look at the top of the model
You will see four spikes on the outside. Pull them down and out as if you were peeling a banana.
Step 23. Show your complete origami to all your friends
Watch their wondering reactions.