Ever wanted to make a bong easily, quickly, and economically, only to realize halfway through the job that you didn't have a bowl to smoke from? Here's how to fix it.
Steps
Step 1. Poke a hole through a 2 liter bottle with a cigarette where you want to put the filter - usually near the bottom
Step 2. Break a pen in half and insert it into the hole you just made
Make sure it is at the correct angle where it exits the bottle.
Step 3. To create a compressed air seal, hold the pen firmly and wrap black tape around the part of the pen closest to the bottle
Step 4. Take at least one meter of aluminum foil, then roll it around a cylindrical bottle and slide the aluminum halfway down the bottle
Step 5. Grab the foil around the bottle and roll up the other end of the foil
Make sure you don't over tighten or you will seal it too much. Slide the bottle out and you should have gotten the ball.
Step 6. If the finer end of the tinfoil does not fit into the pen, place the bowl on top of the pen and press lightly to seal it tightly, then wrap black tape around the pen and aluminum near the pen to hold it. stop
Make sure you tighten it tightly so it fits snugly.
Step 7. Make two more holes around the top of the bottle with the cigarette
(These will act as carburetors).