A Cascade Bong pulls better, and it's cool.
Steps
Step 1. Make a 1/2 inch hole in the bottle cap with a sharp object, such as a knife or pen
Step 2. Insert the connector into the hole made in the cap
This will be your burner stove.
Step 3. Make a small hot hole in the bottom of the bottle to use as a carburetor
Step 4. Remove the cap from the bottle and fill it with water to about 2.5 centimeters from the top, holding the carburetor closed with your finger
Step 5. Screw the cap into place, and fill the stove with the smoking material of your choice
Step 6. Remove your finger from the carburetor, as the water comes out of the hole, turn on the stove, as the water level drops, it will suck smoke from the stove
Step 7. When all the water has come out of the carburetor, plug it again with your finger
Step 8. Unscrew the burner and vacuum from the mouthpiece, removing your finger from the carburetor to remove all smoke
Advice
- For better airtightness and better overall suction, consider using a glass stove and a rubber gasket for another bong.
- It will be better to pulverize the smoking material, as this will facilitate better airflow than solid material.
- Instead of using a stove, roll a joint (or joint) and insert it into the hole made in the cap. If the spinel doesn't cover the hole tightly, use your fingers to plug the rest of the hole. While you wait for the bottle to be refilled, you can smoke the joint directly.
- It is possible to make a hole in the bottle using the flame of a lighter.
- To pull better, insert the plastic tube of a Bic pen inside the hole made on the cap, then attach a straw cut to size at the end. This will allow a better percolation on the bottom, which can be further improved by plugging the straw and making a dozen small holes at the end, thus allowing a better diffusion of the smoke, as well as increasing its cooling.
- Another way to easily drill a hole without using a drill is to use a pair of scissors and, once the hole has been made, widening it by rotating the scissors inside until the stove can fit comfortably.
- A simple way to make a stove is to shape it with aluminum foil, then applying it directly to the mouth where the cap would be screwed. Make small holes in the aluminum foil so that the smoke can pass through.
- If the stove does not fit tightly with the lid, use wax or rubber to seal it.
Warnings
- The smoke might bother you a bit as it enters your lungs.
- The water could get dirty.
- It will be difficult to seal the holes perfectly.
- If the water comes out too slowly from the carburetor, widen it, however keeping it the right size so that it can then be plugged with a finger.
- Prolonged use of a lighter flame to drill the hole in the plastic could result in a hole that is too large, and / or weaken the plastic too much.
