This is an easy-to-follow method of making a bong that can be used to smoke tobacco or any other flammable legal substance. This article is good for both beginners and those with more experience.
Steps
Step 1. Refer to the figure for the elements you will need to create a bong
Step 2. Remove the Gatorade or water cap and pierce it in the middle
Step 3. Use scissors to help you
Step 4. Tear off a small piece of aluminum to wrap the cap
Step 5. Use your finger to better shape the shape of the aluminum
Step 6. Insert the aluminum inside the cap
Step 7. This is your bong filter, so you need to drill some holes
Make sure they aren't too big to avoid eating tobacco.
Step 8. Take the plastic bottle and cut it so that there is enough room for smoking
Step 9. Cut another piece of plastic, as shown in the image above
Step 10. Fill the container with water
Step 11. Insert the tobacco over the cap
Step 12. Insert the bottle into the water container
Step 13. Light the tobacco and as you inhale slowly pull the bottle towards you
Step 14. When the bottle fills with smoke, remove the cap and inhale slowly for a few seconds
Advice
- Gatorade bottles work best because they are thicker and sturdier than a standard bottle. In addition, the cap is wider and easier to work with.
- Make sure you poke the hole high enough so that no water gets in. Also make sure to cover the hole with your finger when you have filled the bottle with smoke, to vacuum properly.
- If you have a regular bong, use its filter.
Warnings
- Don't drink the water from the bong
- Do not carbonize the aluminum foil
- Tobacco can cause lung cancer, smoke responsibly
- Lighters heat up after use.
