How to Replace a Bathroom Sink: 14 Steps

Table of contents:

How to Replace a Bathroom Sink: 14 Steps
How to Replace a Bathroom Sink: 14 Steps
Anonim

Bathroom sinks can get chipped, scratched, or stained, and you may want to change one to give your bathroom a newer, tidier look. Replacing a sink can be time consuming but it shouldn't be hard to do, and it will definitely make the whole room look more beautiful.

Steps

Replace a Bathroom Sink Step 1
Replace a Bathroom Sink Step 1

Step 1. With a tape measure, measure the old sink

When you install a new one, it will have to fit in the old plan. Note the length, depth and width of both the sink and the surface on which you will mount it.

Replace a Bathroom Sink Step 2
Replace a Bathroom Sink Step 2

Step 2. Buy a new sink

Bring the measurements of the old sink and the counter with you, to be sure to choose one of the right size.

Replace a Bathroom Sink Step 3
Replace a Bathroom Sink Step 3

Step 3. Remove the water

The knob to turn off the water is usually located under the sink, and to make sure the water has turned off, try turning the knob on the faucet.

Replace a Bathroom Sink Step 4
Replace a Bathroom Sink Step 4

Step 4. Place a bucket under the siphon

The first thing to do is to remove the exhaust pipes.

  • Using parrot pliers, loosen the siphon bolts.
  • Place the siphon on the bucket, after gently removing it from the sink.
Replace a Bathroom Sink Step 5
Replace a Bathroom Sink Step 5

Step 5. Unhook the hot and cold water hoses from the faucet with a wrench

Assembling a sink involves having to spend time under it to remove various pieces.

Replace a Bathroom Sink Step 6
Replace a Bathroom Sink Step 6

Step 6. With a screwdriver, remove the screws holding the sink to the counter

Replace a Bathroom Sink Step 7
Replace a Bathroom Sink Step 7

Step 7. With a utility knife, remove all silicone residue between the countertop and the sink

Replace a Bathroom Sink Step 8
Replace a Bathroom Sink Step 8

Step 8. Lift the old sink off the counter

The surface must be clean and flat, so it eliminates all silicone residues.

Replace a Bathroom Sink Step 9
Replace a Bathroom Sink Step 9

Step 9. Remove the faucet and drain hoses from the old sink if you want to reuse them with the new one as well

Replace a Bathroom Sink Step 10
Replace a Bathroom Sink Step 10

Step 10. Fit the old sink and drain to the new sink

You need to seal the pieces well, so apply a layer of silicone to the faucet and base of the drain. If you buy a new tap instead, consult the instruction manual for installation.

Replace a Bathroom Sink Step 11
Replace a Bathroom Sink Step 11

Step 11. Apply silicone to the bottom edge of the sink

Place it along the space provided on the top, fix it in place and remove excess silicone with wipes.

Replace a Bathroom Sink Step 12
Replace a Bathroom Sink Step 12

Step 12. Attach the sink to the counter with screws, applying them from the counter towards the sink

Make sure it is securely attached.

Replace a Bathroom Sink Step 13
Replace a Bathroom Sink Step 13

Step 13. Reconnect the water pipes with the wrench and the siphon with the parrot pliers

Do not over tighten the screws.

  • Put the water valves back on. Leave the bucket under the sink while you test the pieces, in case there are any leaks. Sometimes it can happen.
  • Open the hot water valve and then the cold water valve. If there are any leaks, turn off the water and re-fit the gaskets, also using Teflon tape on the pipe.

Recommended: