Building a vaporizer is not only easy, it will also save you some money. Use some household items to make yours in minutes.
Steps
Method 1 of 3: Building a Vaporizer with a Light Bulb
Step 1. Prepare what you need
For this type of vaporizer you will need a bulb bulb (100 watts are best), a sharp knife, tongs, glass straws or tubes, duct tape, scissors and the cap of a 500ml bottle.
Step 2. Cut the end of the bulb
Use the knife to remove the metal end where the bulb is usually screwed. Try to cut it evenly to avoid sharp edges.
Step 3. Remove the filament
Use the pliers to do this. The filament is that metal wire that lights up the bulb when it is turned on. When you are done with these steps, you should end up with an empty glass bulb.
Step 4. Insert the cap on the open end of the bulb
If it is too big, put some adhesive tape inside to create some thickness and make it adhere perfectly.
Step 5. Drill two holes in the cap
You will need to insert two straws or two glass tubes into these holes, so take your measurements. Help yourself with the knife to pierce the cork. If you have a drill handy, use it to make your job easier.
Step 6. Assemble the vaporizer
Insert the straws / tubes into the cap and check that the latter fits well on the bulb of the bulb. Once you've made sure everything fits together, remove the cap and add your favorite substance to the bulb. Place the bulb over a flame to create the vapor that you can inhale through the two tubes.
Method 2 of 3: Build a Vaporizer with a Glass Vial
Step 1. Prepare what you need
You will need to get a small glass bottle (the one used for the Gingseng extract is the right size), a small straw or tube, a sharp knife and adhesive tape.
Step 2. Clean the bottle
Remove any residue by washing it several times until it is completely clean. Do the same with the plastic cap of the bottle.
Step 3. Drill a hole in the cap
Use the knife to make a hole for the straw to pass through. Avoid leaving rough and sharp edges.
Step 4. Insert the straw into the cap
Make a small hole in the straw at the point where it fits into the cap, to allow the passage of air.
Step 5. Assemble the vaporizer
Put the cap back on the bottle and make sure they fit snugly. When you are sure that everything adheres perfectly, remove the cap and insert the chosen substance into the bottle. Make sure the straw is only halfway into the bottle so it won't melt in the heat and suck up any particles.
Method 3 of 3: Build a Vaporizer with a Glass Cup
Step 1. Prepare what you need
You will need a thin glass beaker, a half-liter bottle, a straw or tube, duct tape, and a sharp knife.
Step 2. Cut the top of the water bottle
Make sure it is empty and the cap is in it. Cut it about 3 cm from the cap.
Step 3. Pierce the cap
Remove it from the bottle before piercing it and, with the help of the knife, make two holes large enough for the straws to pass through. Make sure there are no sharp edges.
Step 4. Insert the straws into the cap
Make sure they don't go too low, they only have to stay halfway in the glass.
Step 5. Put the bottle neck on the glass
The diameter you cut should be enough to make what remains of the bottle adhere to the glass. If not, you can use masking tape to create some thickness and secure them better. Enter the substance you like before sealing the glass to the bottle. Heat everything from the bottom of the glass.
Advice
- If the cap is too small, get a larger one and secure it with tape or glue.
- To use the vaporizer, put the substance on the bottom and then hold it over a flame at about 1-2 cm for a few seconds until you see the vapor, then suck in the straws.
