The messy chignon is a hairstyle that suits all occasions. Learn to do it!
Steps
Method 1 of 4: Pre-Styling (Optional)
Step 1. Brush and detangle your hair
Step 2. Apply a mousse starting from the ends but apply a little
Step 3. Back the hair to create volume
Brush a strand normally, lift it up and comb it backwards to the roots; do it only on its inner side. Repeat until you reach the desired level of backcomb, backcomb as many strands as you want and, when done, pull your hair back.
Step 4. Spray some hairspray if you want
Step 5. Stand upside down and pull your hair back to add volume for an even result
Method 2 of 4: The Most Common Method
Step 1. Gather your hair in a high or low ponytail (the height of the bun will depend on that of the ponytail)
Step 2. Grab the ponytail with one hand and make sure you have a rubber band ready on your wrist
Step 3. Twist the hair around the elastic to create a “donut”
Step 4. Secure the “donut” but leave some strands free and spread out sections of hair held in place by the elastic
If you want, wrap loose strands around the elastic and secure them with a bobby pin.
Method 3 of 4: Alternative Methods
Step 1. Collect the hair in a ponytail
Smooth out unruly locks with a wide-toothed comb and hair cream.
Step 2. Hold the hair in one hand and start making the bun:
- Wrap the elastic around your hair once or twice to make the ponytail. Twist them around the base to create a classic ballerina bun. Flatten it on your head and secure it with another rubber band or, better yet, with bobby pins. Pull some locks from the bun to get the desired effect.
- Use the elastic to secure the tail and brush it to loosen it. If you want, spray the hairspray, twist the hair and secure it with a second rubber band. Alternatively, if you have long enough hair, wrap it around the base of the ponytail and loosely secure it with another elastic. When you're done, gently brush the bun to pull out a few strands.
- Grab your hair and secure it with a rubber band. Pull out the loose ends and secure everything with a second rubber band. The first round of hair may become tighter as you pull the hair to do the second. Thread another rubber band over the first two turns and secure them loosely. For this look, your hair should go over the shoulders by about two inches.
- Grab the hair to make a ponytail, partially secure it with a rubber band and then wrap it around yourself finishing fixing it with the same elastic. Pull a few strands out.
Method 4 of 4: Finishing Touches (Optional)
Step 1. Run your fingers across the front of the hair to loosen it from the elastic and add texture
Step 2. Put on a headband (or two)
Place a thin black one five cm from the hairline. The second, always black and thin, must be placed about eight cm behind the first. If you have blonde hair, black or dark headbands are fine. If you have brown or black, use two white or another light color.
Step 3. Spray the hairstyle with hairspray about 18-20 cm apart
Step 4. Play with the hairstyles
Advice
- The bangs do not necessarily have to be inserted into the chignon.
- Create the hairstyle when the hair is dry.
- Use a brush to detangle your hair.
- Don't worry if the bun doesn't look perfect - that's the point!
- If you have to go out, bring some bobby pins to freshen up the look. If the bun gets too messy, you might want to turn it into a ponytail.
- Tilt your head back to make the tail.
- Do not use rubber bands that tighten too much.
- Make sure you don't overdo the backcombing - damaged ends could ruin the look.
- The best position for this hairstyle is more or less near the top of the head.
- Put on a hair accessory for a prettier result.
- This look can become romantic by curling the strands left out.
- Don't use too many bobby pins and be careful not to hurt yourself while using them.
Warnings
- Too tight rubber bands can break or damage your hair.
- Backcombed hair can be difficult to style - use a flat brush and be patient.
