How to Clean a Steam Iron: 6 Steps

Table of contents:

How to Clean a Steam Iron: 6 Steps
How to Clean a Steam Iron: 6 Steps
Anonim

Keeping an iron perfectly clean and in full working order is relatively simple and requires a few simple steps.

Steps

HalfFullWater Step 1
HalfFullWater Step 1

Step 1. To clean the inside of an iron, you will need to fill the tank halfway with water

Add vinegar until you reach the maximum capacity level.

RunIron Step 2
RunIron Step 2

Step 2. Turn on the iron and let it heat up for about 15 minutes, then let it cool down for about an hour

Drain the solution of water and vinegar left in the iron.

AddWater Step 3
AddWater Step 3

Step 3. Fill the iron with water and repeat the previous step without using vinegar

Drain the water left in the iron, it is now ready for use.

IronCleaner Step 4
IronCleaner Step 4

Step 4. To clean the soleplate of the iron, buy a special product at your local supermarket

Normally the products for cleaning irons are found in the same department as the detergents for washing laundry. These products are used to clean non-stick plates. Always remember to follow the instructions on the product packaging.

NonStickSoles Step 5
NonStickSoles Step 5

Step 5. Non-stick plates are usually self-cleaning and require little maintenance

CleanIron Intro
CleanIron Intro

Step 6. Finished

Advice

  • Burnt starch is easily removed using a wet abrasive sponge. Make sure the iron is cold before cleaning, you will avoid burning yourself.
  • If plastic has melted on the soleplate of the iron, you can remove it without problems. Place a sheet of aluminum foil on the ironing board and sprinkle it with cooking salt. Now pass the hot iron over the aluminum foil, the salt will help remove the plastic from the soleplate of your iron. Never try to remove plastic with metal objects. You could damage the plate irreparably.

Recommended: