3 Ways to Make the Slip Stitch

Table of contents:

3 Ways to Make the Slip Stitch
3 Ways to Make the Slip Stitch
Anonim

The slip stitch or invisible stitch is usually used in crochet and knitting, and is a good way to make "invisible" stitches in hand sewing. There are different methods depending on the processing you prefer. Once you have mastered this point, a whole world will open up to you. There is no reason not to start now! Start with step 1 to learn how to use this very useful point.

Steps

Method 1 of 3: Knitting

Step 1. Know that the stitch can be slid both straight and purl

You can slip the stitch both straight and purl. (Unless stated otherwise, it means straight.)

  • To slip a stitch straight, pull the right needle through the next stitch from left to right, as if you were going to knit. Don't pass the wire over the iron though; simply move the stitch from the left needle to the right needle. This method is more visible.
  • To slip a purl stitch, pull the right needle through the next stitch from right to left, as if you were purl. Simply move the stitch from the left needle to the right needle. This method is practically invisible.

Step 2. Put the yarn in front or keep it behind

Another variant for slipping stitches while knitting is if the unworked yarn remains on the back (from where you usually work) or if it is on the front of the work. If you need to make a slip stitch with the yarn in front, move the yarn as it is between the needles and then in front of the work. After sliding the point, return it to its original position. If not indicated otherwise, consider the slipped stitch with the thread on the back.

Method 2 of 3: Crochet

Step 1. Know the final result

After you've worked a slip stitch, you should only have one stitch left on the hook.

Step 2. Pull the hook through the stitch indicated

Step 3. Pull the yarn over the hook

Step 4. Pull the last stitch (the top yarn) through all the stitches on the hook

You should only have one loop left on the hook.

Method 3 of 3: Hand Sewing

Step 1. Stop the hem

Slip stitches are usually used to sew hems so that the line of stitches is not visible on the outside (or inside) of the dress. Stop the hem first to make sure you sew straight. Your hem should have a "crease" on the inside; the appearance is that of the bottom of a fabric, folded upwards by 2 or 3 cm, then folded again for another 2 cm (or the size you are using).

Step 2. Tie a knot at the end of the thread

C12_64
C12_64

Step 3. Slide the needle into the crease, and pull it out of the top crease

C13_468
C13_468

Step 4. Using the end of the needle, grab a few threads of the fabric above the fold

Do not pass the needle completely through the fabric but only superficially and then pull it back, as you would when sewing normally. Instead bring the tip of the needle under three or four threads of the fabric. By passing the thread in this way, you avoid bumps and pulls on the outside of the garment.

C14_91
C14_91

Step 5. Put the needle back into the fold

Near the point where you pulled the needle out of the fold, push it back in, keeping the needle parallel to the fold. You will move in length along the seam.

C15_348
C15_348

Step 6. Return the needle to the outside of the fold

Again, take a few threads of the fabric right above where the needle came out.

Step 7. Repeat steps 2 through 4 as many times as necessary

C16_972
C16_972

Step 8. Knot

When you're done sewing the hem, tie it so that the knot is inside the fold.

Recommended: